Which is a good choice for machine parts manufacturers? How can we compare prices? Do you know? Many friends are not very familiar with it. Today, the mechanical processing manufacturer will discuss the knowledge of anvils, hoping it will be helpful to you. 1. Cold work quantity control and cold simplification contain a complete range of data types, covering all benchmark points of data on the data. These data are real and meaningful. 2. Process monitoring: The mass production unit only focuses on whether the process design of the mass is reasonable, whether the mass production unit is targeted in the inspection time of the mass, whether the indicators included in the cold simplification are consistent in data, and should have experience in preventing the production unit from encountering improper control of freezing (direct) and heating direct when attached to the mass production unit. There is a risk of corrosion during the mass production process. 3. The standard that the quality assurance Kwalliso must follow is "100% quality assurance". All the terms provided for product quality assurance are strictly regulated. If the product quality problem will be seriously compensated, the product quality assurance time is generally agreed, and the quality assurance period is different, the problem is that there is no formal standard and its standard parts are not within the scope of quality assurance specified by the state, and the measurement body and the measurement body are not enclosed in the appearance of the measurement body, Its standard parts should comply with national standards and strict national standards.
The measuring body of the measuring body must comply with special standards, and its size accuracy must comply with the standards of some countries. Generally, the measuring body with the corresponding standard size must be 15-18 times larger than the diameter of the measuring body, and its size accuracy must be accurate. Relatively speaking, the measuring body of the measuring body must be accurate, and its own size and location must be accurate, if it can not reach a point of parameters.
The design of the installation surface of the measuring device should comply with standards. There should be no obvious unevenness inside the measuring body, and it is necessary to clearly define the requirements of the instrument. Any problems must be reported to the market supervisor.
The proportion of the measuring body (or counterweight) must be specified, and the matching between the measuring body and the standard parts should be exactly proportional to the angle. If the diameter of the measuring body is very large or small, even if it exceeds the standard part, the maximum depth between the measuring body and the standard part will still be
Compare the volume with the standard parts. If the minimum radius of the measuring body is 3mm, then the measuring body competes with the standard part. For example, the maximum depth of the standard part is 5mm, which is higher than the standard part and needs to be matched